So I recently purchased a Sparrow grip that I wanted to try on my S&W Response.
Removed the factory fin grip and saw two springs. I'm assuming one is for the safety and the other is for the takedown pin.
Long story short I misplaced one spring, then the other, then found one of them. Another problem is I found some type of pin in my hand that I don't know where it goes or if it even belongs on the Response. I usually do any kind of work on my bench with a mat underneath. I didn't this time because, well, it's a grip with one allen head fastener so I thought no big deal. This was the first time removing this grip so I didn't know there were a few small parts to go along with it.
Does anyone have a parts diagram so I can see exactly where these parts go? I tried looking on the internet with no success.
I'll be contacting S&W as well, just wanted to check if I may have any luck here first.
Removed the factory fin grip and saw two springs. I'm assuming one is for the safety and the other is for the takedown pin.
Long story short I misplaced one spring, then the other, then found one of them. Another problem is I found some type of pin in my hand that I don't know where it goes or if it even belongs on the Response. I usually do any kind of work on my bench with a mat underneath. I didn't this time because, well, it's a grip with one allen head fastener so I thought no big deal. This was the first time removing this grip so I didn't know there were a few small parts to go along with it.
Does anyone have a parts diagram so I can see exactly where these parts go? I tried looking on the internet with no success.
I'll be contacting S&W as well, just wanted to check if I may have any luck here first.